![]() ![]() My drivers were all up to date and the power management settings were correct so no help there for me. Your controller must be connected in order to see this.Īlso in Device Manger if you change the View to ‘Devices by Container’ you can see the X-controller listed with the USB Serial Converter and the USB serial port. To do this, go to the Device Manager under Ports - USB Serial Port. One setting that I have changed, after the successful carve so I can’t prove it was the problem, is the COM port number ( from 6 to 2 ) and the speed (from 9600 to 115200). So I’ll just have to wait till it fails again. Don’t you just love intermittent problems. I temporarily moved my pc close to the Xcarve then using a short USB cable I ran the same cut ( which had previously failed 4 times) and it worked ! But of course being a pessimist, I reconnected the long active cable and ran it again exactly the same except for no bit and that also worked. Wow, thanks to Dominik and everyone for all the great suggestions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |